Transcutaneous Electrical Nerve Stimulation (T.E.N.S.) unit for pain management and replacement electrodes.

T.E.N.S. may be covered by private insurance, healthcare, Worker's Compensation Board (WCB), or Workplace Safety and Insurance Board (WSIB).

TX3

$189.00
Shipping: $15 or $30

TX3 - Portable Tens Unit
SPECIAL $159.00

Dual-Channel Tens Stimulator, 2 Lead Wires, 4 Self Adhesive Electrodes
Molded Plastic Carrying Case, 9 Volt Battery, Operating Manual
Power Indicator Light
Wave Form: Asymmetrical biphasic square wave, zero net component
Pulse Amplitued: 0 to 80 mA each channel, adjustable, (500 ohm load)
Pulse Rate: 2 to 160 hz, adjustable
Pulse Width: 40 to 260 microseconds, adjustable
Mode Selector: Switch: Burst, Normal, Modulation
Modulation Mode: Pulse width varies in a cyclic pattern over an interval of nominally 5 seconds. Pulse width decreases linearly over a period of 1.5 seconds from the control setting to a value which is 45% less. The narrower pulse width is maintained for 2 seconds, and then increases linearly over a 1.5 second period to its original value. The cycle is then repeated.
Burst Mode: 11 pulses per burst, 2 burst per second, 100
Maximum Voltage: 110 volts, open circuit
Maximum Charge: 21 micro coulombs per pulse
Power Source: 9 volt battery or similar rechargeable cell
Size 23 x64x91mm
3 Year Limited Warranty

TENS TS-1211

$190.00
Shipping: $15 or $30

Digital Tens Unit
$190.00

Technical Specifications

Channels: Dual-Channel Tens Stimulator, 2 Lead Wires, 4 Self Adhesive Electrodes
Molded Plastic Carrying Case, 9 Volt Battery, Operating Manual
Power Source: 9V Batteries
Output Waveform: Asymmetric biphasic square pulse
Pulse Width: Variable, 50-260us
Pulse Frequency: Variable, 2 -150 Hz
Adjustable Intensity Levels: 0-40 Volts (at load=500ohm)
Stimulation Modes: Burst , Normal, MRW, SD, Bi-Pulse

IF 4000

$450.00
Shipping: $15 or 30

Interferential Stimulator
$450.00

Technical Specifications

Carrier Frequency: (4000 +/- 10% Hz Fixed
Difference Frequency: (1 +/- 0.5)~(150 +/- 10%) Hz, adjustable
Output Voltage: (16 +/- 2.5) Volts. (500 Ohm Loading)
Waveform: Symmetric biphasic square.
Pulse Width: (125 +/- 10%) microseconds for each phase.
Power Source: adaptor or 9V alkaline battery.
Four Frequency Shifts: continuous, 1/1 abrupt, 8/8 abrupt, 10/10 ramped, options.

PGS-123
$450.00
Shipping: $15 or $30

Pulsed Galvanic Stimulator
$450.00

Technical Specifications

Power Source: 9V alkaline battery
Output: Single Channel
Output Voltage: 0-240V Max (Single channel, load 500 Ohm)
0-350 Max (Open Current)
Pulse Rate: 2-100 Hz
Waveform: Positive or negative wave form
Output Mode: Synchronous or Alternation
Alternation Mode - LED alternates between green and red color
Power: Green color LED - power on
Red Color LED - Low battery
Pulse Duration: 5 µs
IntraPulse Interval: 100µ
Tolerance: +/- 20%

Electro Conductive Garments Available for use with this unit.
Glove (fits either hand)- Small, Medium, Large
Sock - Small, Medium, Large
Knee or Elbow Sleeve
$129.95 Each
Dispersive Pad Required
4" x 7" $10.95 Each

MC 300

$199.00
Shipping: $15 or $30

Micro Current TENS
$199.00

Technical Specifications

Channels: Dual isolated between channels
Frequency: 0.6Hz - 10 Hz - 30Hz - 300HZ
Amperage Output Adjustale: 0-2mA
Microamps Output Adjustable: 0 to 900
Milliamps Output Adjustable: 0 to 8
Waveform: Square or Slope
Power Supply: 9 Volt battery system
Size: 27 x 62 x95mm

TX3-T

$199.00
Shipping: $15 or $30

TX3T - Portable Tens Unit
SPECIAL $175.00

Dual-Channel Tens Stimulator, 2 Lead Wires, 4 Self Adhesive Electrodes
Timer: 30 minute, 60 minute or constant.
Molded Plastic Carrying Case, 9 Volt Battery, Operating Manual
Power Indicator Light
Wave Form: Asymmetrical biphasic square wave, zero net component
Pulse Amplitued: 0 to 80 mA each channel, adjustable, (500 ohm load)
Pulse Rate: 2 to 160 hz, adjustable
Pulse Width: 40 to 260 microseconds, adjustable
Mode Selector: Switch: Burst, Normal, Modulation
Modulation Mode: Pulse width varies in a cyclic pattern over an interval of nominally 5 seconds. Pulse width decreases linearly over a period of 1.5 seconds from the control setting to a value which is 45% less. The narrower pulse width is maintained for 2 seconds, and then increases linearly over a 1.5 second period to its original value. The cycle is then repeated.
Burst Mode: 11 pulses per burst, 2 burst per second, 100
Maximum Voltage: 110 volts, open circuit
Maximum Charge: 21 micro coulombs per pulse
Power Source: 9 volt battery or similar rechargeable cell
Size 23 x 64 x 91mm
3 Year Limited Warranty

$329.00
Shipping: $15 or $30

GLC-SD Strength Duration Unit
SPECIAL $329.00

Channels: Dual
Pulse Amplitude: Adjustable, 60mA maximum for positive Pulse or -10mA peak maximum for negative pulse 500 om load each channel
Pulse Rate: Adjustable 1Hz - 120Hz
Pulse Width Adjustable 30µs - 225µs
Function Modes: Burst: Cycle Burst,- Normal: Continuous Width: Width Modulation,- SD1: Strength Duration Modulation, - SD11: Strength Duration Modulation
Anti-shock function
Software Ramp up features
Wave Form: Asymmetrical Biphasic square pulse
Voltage (open circuit): 0-40 Volt Maximum. (positive or negative pulse)
Max Charge per Pulse: 20 micro coulombs. Positive and megative pulse separate.
Battery 9 volt battery (regular or rechargable)
Size: 25 x 60 x 97mm
3 Year Limited Warranty